Running a Script Manually Using the CLI
After creating a script you can run the script manually through the CLI. Enter the following:
eqcli >
smart_control run
scname
To see when the Smart Control was last executed, use the following format:
eqcli >
show smart_control
smartcontrlname
where
smartcontrolname
is the name of the smart control.
The following is an example:
eqcli > show smart_control sc-test
This Smart Control is enabled.
Last Execution Time: 11/17/2014 17:07:55
Next Execution Time: 11/18/2014 17:07:55
Smart Control Name
: sc-test
Schedule
:
Interval
: 0
Flags
:
Script
:
echo "test smart control";
Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.
All Rights Reserved.
701
Equalizer Administration Guide
Summary of Contents for Equalizer GX Series
