Coyote Point Systems Equalizer GX Series, Administration Manual

Page: 68 / 866

Sample Configuration
7. Associate an interface instance with the VLAN. In the example below we assume that you
are using the port labeled "1" on the front panel. Enter one of the following commands,
depending on whether the VLAN you created above is untagged or tagged (ask your network
administrator if you are unsure):
eqcli > vlan vlname ifi if01 type untagged
or
eqcli > vlan vlname ifi if01 type tagged
8. Connect Equalizer to your network on the VLANs that you set up in the previous steps, using
the appropriate front panel ports. You should now be able to ping Equalizer’s IP address on
each VLAN. If it does not respond on a VLAN, you may need special routes on the default
router, or on the next-hop gateway for a particular VLAN.
9. Set the timezone. Enter:
eqcli > timezone?
10. Locate your timezone in the displayed list and press
q
to quit out of the list. Then, type in
your timezone number and press <
Enter
>, as in this example for the "America/New York’"
time zone:
eqcli > timezone 161
11. If Equalizer can reach the Internet, add a name server so that NTP will work and time will
be the same across all Equalizers:
eqcli >
name-server IP_address
Otherwise, set the time manually on all systems to the current time:
eqcli >
date HHmmss
12. Create two real servers:
eqcli >
server sv01 proto tcp ip 192.168.0.5 port 80
eqcli > server sv02 proto tcp ip 192.168.0.6 port 80
68 Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.