Failover
Show the cluster parameters by entering :
eqcli >
show cluster cl-tcp
L4 Cluster Name
: cl-tcp
Protocol
: tcp
IP Address
: 172.16.0.131
Port
: 80
Port Range
: 0
Preferred Peer
: Primary
VID
: 1
Server Pool
: testserverpool
Sticky Timeout
: 5
Sticky Netmask
: 0
Idle Timeout
: 5
Stale Timeout
: 5
L4 Flags
:
eqcli >
5. Display the dynamically created failover group by entering
show fogrp
. This command lists
the Failover Groups that have been created, based on the configuration. For example:
eqcli >
show fogrp
F/O Group Name
F/O Group ID
F/O Mode
Primary Peer
Unassigned
0
Not Used
fo_group1
1
Primary
Primary
fo_group2
2
Backup
The
F/O Group Name
“Unassigned” is used:
l
When active-active is NOT enabled on the local peer, all clusters are in the
"Unassigned" F/O Group.
l
If the system cannot determine a failover group in which to place a cluster, pos-
sibly because it was assigned a VLAN IP that does not reside on a defined sub-
net, it goes into Unassigned.
580
Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.
Summary of Contents for Equalizer GX Series
