System Settings
To configure outbound NAT using the CLI:
1. Log in to eqcli as described in
2. NAT can be set up by entering a
from
parameter in CIDR format that specifies the IP range.
The
from
address is the source IP address (or range of addresses) to which this NAT
rule applies. Use a CIDR-format IP address to specify a range. If the source IP
address of an outbound packet matches this IP address (or falls within the specified
range), then the packet is modified to use the IP address specified by the
out
parameter as the source IP.
The
out
address specifies that if the source IP address of an outbound packet
matches the IP address (or IP address range) specified by the
from
parameter, then
the packet is modified to use this IP address as the source IP.
eqcli> vlan
vlan-name
subnet
subnet-name
nat from
ip_cidr
out 1.2.3.33 nat
subnet-name
out gw
gateway ip
308
Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.
Summary of Contents for Equalizer GX Series
