Coyote Point Systems Equalizer GX Series, Administration Manual

Page: 293 / 866

VID : 1
MTU : 1500
Subnets : sn02
Interfaces : agr00
Removing an Aggregated Interface from a VLAN using the CLI:
To remove an aggregated interface from the VLAN used in the previous example above, enter the
following command:
eqcli > no vlan vl00 ifi agrname
Removing an Aggregated Interface from the System using the CLI:
To delete an aggregated interface from the system, you should first remove it from all VLANs that
use it (see above), and then enter the following command:
eqcli >
no agr agrname
Configuring Link Aggregation using the GUI:
To create a link aggregation group and assign it to a VLAN using the GUI, do the following:
1. Click on the
System
configuration tab on the left pane of the GUI if it is not already selected.
2. Click on the arrow (
u
) beside
Network
to expand the branch.
3. Click on
Aggregation
to display the Aggregation configuration screen. The screen features
accordian tabs that will display the configured
Aggregated Interfaces
when clicked. The
example below shows E670LX/E970LX.
4. Click on on the
Aggregated Interfaces
configuration screen. The
Add Aggregated Interfaces
dia-
logue shown below will be displayed. (E670LX/E970LX shown)
Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.
All Rights Reserved. 293
Equalizer Administration Guide