Coyote Point Systems Equalizer GX Series, Administration Manual

Page: 160 / 866

Working in the CLI
Resetting Your Password
You can reset your password to the default by entering the following when your unit is rebooting:
1. Enter
CTRL+C
when prompted for a
username
. This will enter the debug mode.
2. Enter the following:
debug > reset passwd
Reset password successful.
debug >
3. Enter
exit
to return to eqcli login prompt.
Note - The "reset passwd" command may fail with the following error message:
cli_reset_passwd: 68400010: Could not complete 'get user' request.:
Connection refused
Unable to reset 'touch' password.
This indicates that the configuration management daemon is not available to process the command. If successive
attempts to run this command fail with the above error message, contact technical support.
Resetting the Configuration
This command resets Equalizer configuration to a factory installed condition. All VLANs, subnets,
clusters, servers, SSL certificates, and other user-supplied objects and settings will be removed.
After the configuration has been reset, the system will be rebooted.
1. Enter
CTRL+C
when prompted for a
username
. This will enter the debug mode.
2. Enter the following:
debug > reset config
WARNING! This command resets the Equalizer configuration to a
factory installed condition. All VLANs, subnets, clusters, servers,
SSL certificates, and other user-supplied objects and settings will
be removed. After the configuration has been reset, the system will
be rebooted. Do you want to continue (Y/N)?
3. Select
Y
or
N.
4. Enter
exit
to return to
eqcli
login prompt.
160 Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.