Club Car CARRYALL 272, Maintenance And Service Manual

Page: 33 / 312

BODY AND TRIM Rear Seat Support
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 4-9
4
REAR SEAT SUPPORT
Read General Warning, Section 1, Page 1-1.
REAR SEAT SUPPORT REMOVAL (CARRYALL 472/XRT 1200 SE)
1. Lift rear seat cushion and remove from the vehicle.
2. Remove eight 1/4-20 flange nuts (21) and eight 1/4-20 x 3/4-inch carriage bolts (20) and remove arm
rests (10 and 11) (Figure 4-4, Page 4-10) .
3. Remove four 1/4-20 x 1 inch, phillips drive, truss-head machine screws (19) and lockwashers (18) from
seat back support (22) and remove seat back (16) and seat back cap (17).
4. Remove four 5/16-18 flange locknuts (24) and four 5/16-18 x 3/4-inch carriage bolts (23) and remove
seat back support (22).
5. Remove seat bottom rear trim (13) by pushing-out, from the back of the seat back support (22), five plas-
tic barrel connectors (12).
6. Remove the seat bottom front trim (14) by lifting the lower inside flange slightly across the entire seat
area. Push the trim toward the rear of the vehicle, allowing the top flange to slide away from the seat
frame toward the rear of the vehicle.
REAR SEAT SUPPORT INSTALLATION (CARRYALL 472/XRT 1200 SE)
1. Slide the seat bottom front trim toward the front edge of the seat frame with the top flange of the trim slid-
ing over the top of the frame. Push toward the front of the vehicle until the lower flange snaps into place.
The top and bottom flanges of the trim should be in direct contact with the frame structure.
2. Install the seat back support (22) in reverse order of removal. Tighten hardware to 15 ft-lb (20.34 N·m).
3. Install a new seat bottom rear trim using new barrel connectors.
4. Install arm rests (10 and 11) in reverse order of removal. Tighten hardware to 65 in-lb (7.345 N·m).
5. Install seat back (16) and seat back cap (17) in reverse order of removal. Tighten hardware to 6 ft-lb
(8.136 N·m).
6. Install bottom bench seat, aligning the front edge of the seat against the inside edge of the front trim, and
push down into place.