Club Car CARRYALL 272, Maintenance And Service Manual

Page: 277 / 312

MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Unitized Transaxle Installation
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 16-21
16
28. Connect accelerator cable to actuator cam in the electrical box. Position the accelerator cable in mount-
ing slot in the wall of the electrical box and tighten mounting nuts to 18 in-lb (2.0 N·m) (Figure 16-51,
Page 16-21) . Install electrical box cover and tighten mounting screw to 18 in-lb (2.0 N·m).
29. Pull fuel line from impulse line fitting of the fuel pump and connect it to the carburetor and secure with a
hose clamp (Figure 16-52, Page 16-21) .
30. Connect the impulse line to the fuel pump and secure it with the hose clamp (Figure 16-53, Page 16-21) .
31. Connect air intake hose to carburetor and secure hose clamp (Figure 16-54, Page 16-21) .
32. Connect carburetor vent tube to carburetor and secure with hose clamp (Figure 16-55, Page 16-22) .
33. Connect the differential lock cable end to the differential lock handle.
33.1. Connect the end of the differential lock cable to the differential lock handle (Step 1) (Figure 16-56,
Page 16-22) .
33.2. Push down on the cable to secure the end of the cable to the differential lock handle (Step 2).
33.3. Rotate the cable counterclockwise to route the cable through the bracket (Step 3).
33.4. Push the cable sheath toward the front of the vehicle to secure the cable to the bracket
(Figure 16-60, Page 16-27) .
33.5. Secure the cable to the vertical support with a wire tie (6).
Figure 16-51 Connect Cable to Cam Figure 16-52 Connect Fuel Line
Figure 16-53 Impulse Line Figure 16-54 Air Intake Hose
TOP VIEW
ACCELERATOR CABLE
CLAMP
IMPULSE LINE
CLAMP