Club Car CARRYALL 272, Maintenance And Service Manual

Page: 280 / 312

MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Forward/Reverse Shifter Cable
Page 16-24 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
16
FORWARD/REVERSE SHIFTER CABLE INSTALLATION
1. Route the cable to the transaxle shifter lever, beginning at the Forward/Reverse shifter.
2. Secure the cable with retaining nut (5) on each side of the shifter cable support bracket at the transaxle
(Figure 16-59, Page 16-24) and tighten nuts to 22 ft-lb (29.8 N·m).
3. Secure the cable with retaining nut (5) on each side of the shifter cable support bracket at the Forward/
Reverse assembly and tighten nuts to 22 ft-lb (29.8 N·m).
4. Install the ball joint socket (10) on the shifter lever ball stud (11) on the transaxle.
5. Install the ball joint socket (2) on the Forward/Reverse shifter assembly ball stud (3).
6. Install wire tie (8) to secure wire harness to cable at the support bracket near the Forward/Reverse shifter
assembly. See following WARNING.
ý
WARNING
• If wires are removed or replaced, make sure wiring and/or wiring harness is properly routed
and secured to vehicle frame. Failure to properly route and secure wiring could result in
vehicle malfunction, property damage or personal injury.
Figure 16-59 Forward/Reverse Shifter Cable
ClubC
ar
CO
M
NC
NO
1
9
7
8
5
11
10
4
3
2
5