Club Car CARRYALL 272, Maintenance And Service Manual

Page: 230 / 312

FUEL SYSTEM Engine Control Linkage
Page 14-6 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
14
ENGINE CONTROL LINKAGE
See General Warning, Section 1, Page 1-1.
GENERAL INFORMATION
It is important that the accelerator pedal, governor linkage, and throttle adjustments are done correctly and in
the proper sequence.
See following CAUTION .
CAUT ION
• Improper adjustment can result in poor vehicle performance and/or damage to the engine
components.
ACCELERATOR ROD
ý
DANGER
• To ensure the vehicle does not run over you while you disconnect or adjust the accelerator
push rod, do the following:
- Turn key switch OFF, place Forward/Reverse handle in the NEUTRAL position and remove
key before servicing the vehicle.
- Disconnect battery and spark plug wire(s). See Disconnecting The Battery on page 1-3.
Accelerator Rod Removal
1. Place chocks at the rear wheels and lift the front of the vehicle with a chain hoist or floor jack. Place jack
stands under the outer front frame I-beam of the vehicle and lower onto stands. See Figure 5-2,
Section 5, Page 5-3. See preceding DANGER. See WARNING “Lift only one end...” in General
Warning, Section 1, Page 1-1.
2. Disconnect the ball joint (1) from the ball stud (2) on the accelerator pedal (Figure 14-4, Page 14-6) and
from the bell crank at the electrical box (Figure 14-6, Page 14-8) .
Figure 14-4 Accelerator Rod
1
2
3