Club Car CARRYALL 272, Maintenance And Service Manual

Page: 272 / 312

MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Unitized Transaxle Installation
Page 16-16 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
16
Unitized Transaxle Installation, Continued:
6. Install the differential lock cable and bracket.
6.1. Connect the differential lock cable spring (1) to the differential lock arm on the housing
(Figure 16-36, Page 16-16) .
6.2. Install two bolts (2) to secure cable bracket to the transaxle case and tighten to 134 in-lb (15.1 N·m).
7. Install the accelerator cable bracket on transaxle case and tighten screws to 134 in-lb (15.1 N·m)
(Figure 16-38, Page 16-16) .
8. Install the governor cable bracket on transaxle case and tighten the mounting screws to 134 in-lb (15.1
N·m) (Figure 16-39, Page 16-17) .
9. Loosely install governor lever arm on governor shaft (Figure 16-40, Page 16-17) . Turn the governor arm
shaft counterclockwise until it stops. Pull the governor lever arm rearward until the carburetor throttle is
in the “wide open throttle” (WOT) position.
10. Hold the arm and shaft in the fully counterclockwise position and tighten the governor arm lever nut to
35 in-lb (4.0 N·m) (Figure 16-40, Page 16-17) .
Figure 16-36 Differential Lock Bracket Installation Figure 16-37 Transaxle Mounting
Figure 16-38 Accelerator Cable Bracket
2
ClubCar
1
Club
Car
ClubCar
(TYPICAL 4 PLACES)
TRANSAXLE MOUNTING
NUTS
(TYPICAL 2 PLACES)
WOODEN
BLOCKS
TRANSAXLE MOUNTING
HARDWARE
BRACKET