Club Car CARRYALL 272, Maintenance And Service Manual

Page: 31 / 312

BODY AND TRIM Front Seat Support
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 4-7
4
Light Soiling – A solution of 10% liquid dish soap and warm water applied with a soft, damp cloth is
recommended. A soft bristle brush may be used if necessary. Wipe off any residue with a water damp-
ened cloth.
Difficult Stains – Dampen a soft, white cloth with a solution of 10% household bleach (sodium
hypochlorite) and 90% water. Rub gently to remove stain, then rinse with a water dampened cloth to
remove bleach concentration.
For More Difficult Stains – Perform previous procedure using full-strength bleach, or allow bleach to
puddle on affected area for approximately 30 minutes. Rinse with a water dampened cloth to remove
any remaining bleach concentration.
SEAT ADJUSTMENT
1. Remove seat (2) from vehicle.
2. Disassemble seat (2) from seat panel (3) by removing four bolts (4) and lockwashers (5) (Figure 4-3,
Page 4-8) .
3. Adjust seat to preferred position. Align holes in seat panel (3) with holes in seat (2) and secure with four
bolts (4) and lockwashers (5). Tighten bolts to 96 in-lb (10.8 N·m). See following WARNING.
ý
WARNING
• Make sure seat hinges and latch are securely engaged before operating vehicle.
FRONT SEAT SUPPORT
Read General Warning, Section 1, Page 1-1.
FRONT SEAT SUPPORT REMOVAL
1. Completely remove both front seats (2) from the vehicle (Figure 4-3, Page 4-8) .
2. Remove park brake equalizer cable from park brake handle. See Equalizer Cable Removal, Section 6,
Page 6-33.
3. Disconnect cable from differential lock control. See step 5 in Unitized Transaxle Removal, Section 16,
Page 16-7 .
4. Remove four hex-head bolts (8), eight washers (9) and four locknuts (10) from the seat support
(Figure 4-3, Page 4-8) .
5. Remove the two armrests (11 and 12) from the seat support (1).
6. Lift seat support (1) from vehicle.
FRONT SEAT SUPPORT INSTALLATION
1. Reverse the front seat support removal process (Figure 4-3, Page 4-8) .
2. Assemble bolts (8), washers (9), and locknuts (10) to seat support and armrests (11 and 12) and tighten
bolts (8) to 13 ft-lb (17.6 N·m). See following WARNING.