Club Car CARRYALL 272, Maintenance And Service Manual

Page: 219 / 312

FE400 ENGINE Crankcase
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 13-5
13
OIL LEVEL SENSOR
Testing the Oil Level Sensor
See Test Procedure 21, Section 11, Page 11-32.
Oil Level Sensor Removal
1. If not already removed, remove crankcase cover. See Crankcase Cover Removal on page 13-4.
2. Disconnect the oil level sensor wire (2) from the cord connection (1) (Figure 13-4, Page 13-5) .
3. Remove the two mounting screws (8) from inside of the crankcase cover and remove the oil level sensor
and bracket.
Oil Level Sensor Installation
1. If the oil level sensor was removed from the bracket, install sensor (6) into bracket (5) and secure with
three screws (7) and tighten to 17 in-lb (1.9 N·m) (Figure 13-4, Page 13-5) .
2. Position the sensor and bracket on inside of crankcase and install two mounting screws (8).
3. Connect sensor wire (2) to cord connector (1) (Figure 13-4, Page 13-5) .
4. Install screw (3) through wire clamp and into crankcase cover. Tighten to 30 in-lb (3.4 N·m).
Figure 13-2 Oil Level Sensor Wire Figure 13-3 Crankcase Cover
Figure 13-4 Oil Level Sensor
STARTER/
GENERATOR
11
12
3
4
1
2
5
5
TYPICAL 2
PLACES
TYPICAL 3
PLACES
1
4
3
2
9
8
5
6
7