Club Car CARRYALL 272, Maintenance And Service Manual

Page: 260 / 312

MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Axle Shaft
Page 16-4 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
16
Axle Shaft, Bearing, and Oil Seal Removal, Continued:
5. To remove the wheel bolt flange on the MC012C transaxle (Figure 16-5, Page 16-4) :
5.1. Remove rubber boot (26) from large flat washer (23).
5.2. Remove cotter pin (25) from locking nut cap (27).
5.3. Remove the locking nut cap (27) from the flanged nut (24).
5.4. Remove the flanged nut (24) and large flat washer (23) from the axle end.
5.5. Remove the wheel bolt flange (22) from the splined axle end.
6. Use a 90° internal snap ring pliers (0.090-inch tip) to remove internal retaining ring from axle tube
(Figure 16-5, Page 16-4) .
7. Carefully pull the axle shaft and bearing straight out of the axle tube.
8. Position a 16-inch (40 cm) rolling head prybar (Figure 16-6, Page 16-4) under the inside lip of the seal
and pull the oil seal out (Figure 16-7, Page 16-4) . Discard the oil seal. See following CAUTION.
ý
CAUTION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal. A damaged
tube might have to be replaced.
9. Inspect the bearing. Remove and replace if damaged or worn (Figure 16-8, Page 16-6) .
Figure 16-5 Axle Retaining Ring Pliers Figure 16-6 Rolling Head Prybar
Figure 16-7 Axle Seal
24
27
25
26
23
22
Insert prybar under
seal, then pull seal out
of its axle tube seat.