![background image](http://html1.mh-extra.com/html/carrier/aquaforce-30xv140/aquaforce-30xv140_controls-start-up-operation-service-and-troubleshooting-instructions_2562366225.webp)
225
TROUBLESHOOTING GUIDE
Table 174 shows potential unit issues and possible solutions. This
table is meant only as a guide, and is not exhaustive in issues or
solutions.
Table 174 — Troubleshooting
LEGEND
SYMPTOM
POSSIBLE CAUSE
POSSIBLE REMEDY
Unit Does Not Run
Check for power to unit
• Check overcurrent protection device.
• Check non-fused disconnect (if equipped).
• Restore power to unit.
• Check Active Capacity Override, CAPA_override.
Wrong or incorrect unit
configuration
Check unit configuration.
Active alarm
Check Alarm status. See the Alarms and Alerts section and follow troubleshooting instructions.
Active operating mode
Check for Operating Modes. See the Operating Modes section and follow troubleshooting instruc-
tions.
High pressure switch (HPS) open
• Recheck high pressure switch.
• Check HPS wiring in compressor VFD.
VFD Enable
• Check VFD enable output from SIOB J6-DO04 for 24VAC.
• Check wiring in compressor VFD at terminals 13 and 27.
Unit Operates Too Long or
Continuously
Low refrigerant charge
Check for leak and add refrigerant.
Air in chilled water loop
Purge water loop.
Non-condensables in
refrigerant circuit
Remove refrigerant and recharge.
Inoperative EXV
• Check EXV, clean or replace.
• Check EXV cable, replace if necessary.
• Check EXV board for output signal.
Load too high
Unit may be undersized for application.
Circuit Does Not Run
Active alarm
Check Alarm status. See the Alarms and Alerts section and follow troubleshooting instructions.
Check Active Capacity Override, CAPA_override.
Active operating mode
Check for Operating Modes. See the Operating Modes section and follow troubleshooting instruc-
tions.Check Active Capacity Override, CAPA_override.
Circuit Does Not Load
Active alarm
Check Alarm status. See the Alarms and Alerts section and follow troubleshooting instructions.
Active operating mode
Check for Operating Modes. See the Operating Modes section and follow troubleshooting instruc-
tions.
Low saturated suction
temperature
See Capacity Control Overrides #23 and #24.
High circuit suction superheat
The circuit capacity is not allowed to increase if circuit superheat is greater than 36°F (20°C).
• Check for faulty suction transducer or wiring.
• Check for restriction in liquid line (filter drier, service valve, etc.).
• Check EXV operation.
• Check for proper refrigerant charge.
Low suction superheat
The circuit capacity is not allowed to increase if circuit superheat is less than 18°F (10°C).
• Check for faulty suction transducer or wiring.
• Check for restriction in liquid line (filter drier, service valve, etc.).
• Check EXV operation.
• Check for proper refrigerant charge.
Low discharge superheat
The circuit is not allowed to increase if discharge superheat is below 16.2°F (–8.8°C).
• Check for faulty suction transducer or wiring.
• Check for restriction in liquid line (filter drier, service valve, etc.).
• Check EXV operation.
• Check for proper refrigerant charge.
Compressor or Fans Do Not
Run
Active alarm
Check Alarm status. See the Alarms and Alerts section and follow troubleshooting instructions.
Active operating mode
Check for Operating Modes. See the Operating Modes section and follow troubleshooting instructions.
VFD fuses blown
Check compressor and fan VFD fuses and replace if necessary
Chilled Water Pump is ON, but
the Machine is OFF
Evaporator freeze protection
Chilled water loop temperature too low. Check evaporator heater.
EXV
—
Electronic Expansion Valve
HPS
—
High Pressure Switch
VFD
—
Variable Frequency Drive
Summary of Contents for AquaForce 30XV140
