E. Fixing System
1. Points to Note When Installing the Fixing Heater
1) Do not touch the surface of the heater.
2) For both heaters, install them with the side with the longer heater wire toward the
front.
3) Install the main heater (790 W) on the right and the sub heater (410 W) on the left
(viewing from the front).
4) Connect the heater wire on the right to the main heater and the one at the top to the
sub heater (when viewing from the rear).
2. Adjusting the Position of the Fixing Assembly Inlet Guide
•
Points to Note in the Field
q
For the position, see the diagram.
w
The “low” position is when the solenoid (SL16) is ON.
e
Make sure the difference in height of the inlet guide between front and rear is 0.5 mm
or less.
r
To adjust the height of the inlet guide, loosen the fixing screw on the height adjusting
support plate.
t
Make checks by removing the lower roller.
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
11-38
