4. Removing the Deck Lifter Motor (M102)
1) Open the compartment of the deck; remove all copy paper, if any.
2) Turn on the copier; if the lifter of the deck is up, push the sensor lever
q
of the paper
supply position inside the compartment with a finger. Stop the lifter
w
about 7 cm
from the base of the compartment, and insert a hex wrench
r
into the hole of the
lifter drive shaft
e
, and fix the lifter drive shaft
e
temporarily in place to prevent it
from turning.
Figure 8-403
Figure 8-404
3) Remove the compartment from the deck. (See p. 8-30.)
4) Disconnect the two connectors
t
, and remove the five screws
y
; then, remove the
deck lifter motor unit
u
.
Figure 8-405
t
y
y
u
7cm (approx.)
w
e
r
q
w
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 PAPER DECK-A1
8-37
