7. Installing the Process Unit
Install the process unit by reversing the steps used to remove it with the following in
mind:
1) When placing the processing unit, be sure to align it along the guide plates
q
at the
front and the rear of the left rail.
On the right rail side, be sure to place the process unit on the L-shaped stay.
Figure 7-414 (rail side)
2) After inserting the process unit into the copier, match the cut-in of the drum shaft and
the cut-in of the drum using the drum rotating tool
e
; then, insert the drum fixing tool
t
, and fit the mounting screw
r
into the center hole of the drum to fix it in place.
Figure 7-415
e
r
t
q
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
7-21
