Reference:
To form a loop, wind the wiring wire around a hex key once; then, turn the hex key
three to four times, and twist the wire.
5) Cut the twisted charging wire (excess) with a nipper.
6) Hook the loop on the stud A shown in Figure 4-331.
7) After stringing it 31 runs, route it through section B, and give it a half turn; then, lead
it between the washer and the motor unit, and wind it around the mounting screw
once (clockwise), and fix it in place with a mounting screw.
Figure 4-331
8) Cut the excess charging wire with a nipper.
9) Tighten the screw loosened in step 3).
Turn the screw until the tension of the grid wire is even.
Pay attention to avoid deformation and slack; if necessary, try to tighten the mounting
screw on the left/right shielding plate at the front earlier.
10) Tighten the mounting screws loosened in steps 1) and 2).
11) Wipe the grid wire with lint-free paper moistened with alcohol.
q
Check to make sure that the grid wire is not bent or twisted.
w
Check to make sure that the wire is strung at equal intervals (i.e., it is in the
groove of the block).
Stud A
Screw
B
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
4-57
Caution:
