3) Loosen the two screws on the metal clamps used to fix the scanner drive cable to
the No. 1 mirror mount.
Figure 3-513
4) Remove the tool.
7. Adjusting the Scanner Home Position
Make copies, and remove the control panel; then, check to make sure that the line
of section A of the electrode mount (front of the No. 1 mirror mount) is in section B of the
hole in the glass support (front).
If not, change the value of ‘BRAKE_SC’ in service mode (
) so that the line
of section A is in section B.
Figure 3-514
B
No. 1 mirror mount
Electrode mount (front)
Section A (left of wall)
Glass support
(front)
Hole
]
3
]
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 EXPOSURE SYSTEM
3-30
