III. RELOCATING THE MACHINE
If you must relocate the machine after installation by truck or other means of
transportation, perform the following steps:
A. Observe the following if you are using stairs when moving the machine into or out
of the user’s:
1. Be sure to remove the fixing/feeding unit assembly, holding tray, and copy paper;
and ship them separately from the machine. (If an RDF is installed, be sure to
detach it also.)
2. When lifting the machine, do not use the grips on the pick-up assembly/delivery
assembly; rather, support it at the four corners of its bottom.
B. Check to make sure that the two adjusters (front) on the bottom of the machine are
facing up and released. The adjusters can slip out; take care not to lose them.
C. When moving the machine in and out of the site of installation, be sure to remove
the Paper Deck-A1 (accessory).
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 INSTALLATION
9-31
Work
Make a copy in Direct.
Remove all copy paper from the
left/right paper deck and each cassette.
Turn off the power switch, and
disconnect the power plug from the
power outlet.
Fix the No. 2 mirror mount in place with
the locking plate from the left cover
side.
Remove the developing assembly.
Tape the following in place so that they
will not be shaken out of place during
transport: transfer charging assembly,
fixing/feeding unit assembly releasing
lever, holding tray assembly, and
holding tray feeding assembly.
Tape the following in place: front door,
hopper cover, each cassette, left/right
paper deck cover, and machine right
door (upper/lower).
Place A3 copy paper on the copyboard
glass, and tape the copyboard cover or
the RDF in place.
Step
1
2
3
4
5
6
7
8
Checks
Check to make sure
that the lens is within
lens hood.
Check to make sure
that the No. 2 mirror
mount will not move.
Ship the developing
assembly separately.
Remarks
Caution:
