7) Cut the excess charging wire with a nipper.
8) Pick the end of the charging wire tensioning spring with tweezers, and hook it on the
charging electrode.
In the case of the transfer charging assembly, hook it on the pin at the front.
Figure 4-327
After stringing the wire, check to make sure that
• It is not bent or twisted in the middle and its gold plating has not peeled.
• It is in the V-groove of the charging wire positioner.
Figure 4-328 Primary Charging Wire
9) Install the cushion at the front of the charging wire. (This does not apply to the
primary charging assembly.)
10) Install the shielding plates (left, right).
For other charging assemblies, install the two lids.
(correct)
(wrong)
Grid side
(correct)
(wrong)
COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
4-55
Caution:
Caution:
