CAE Healthcare Fidelis Lucina, User Manual

Page: 347 / 390

Müse Parameter Descriptions
319
FHR Signal Loss
The FHR Signal Loss parameter controls the overall quality of the fetal heart rate signal to emulate
quality of the probe installation. This parameter indicates the relative amount of signal loss as a
percentage. 0% is a clean signal with no loss. 100% results in no signal. Intermediary values create
progressively larger gaps of data on the graph. The FHR widget displays “-“ when there is no valid data.
This parameter is applied, regardless of the probe type. Instructors can create various FHR signal quality
scenarios by using this control and the probe type selection.
Default : 0
Range : 0 - 100
UA Signal Loss
The UA Signal Loss parameter controls the overall quality of the uterine activity signal. When set to
“yes”, the uterine activity signal is set to 0 regardless of the probe type.
Default : No
TOCO Offset
The TOCO Offset parameter is applicable only if the UA probe selected is TOCO. This parameter is used
to shift the uterine activity signal by adding/removing a fixed pressure offset to the uterine pressure. It
is useful to emulate conditions such as a tight UA probe belt. The effect is only from the change,
previous historical data is not changed.
Default : 0
Range : -100 - 100
MHR Graph
The MHR Graph parameter activates the display of the maternal heart rate over the FHR display, when
set to “on”. The maternal heart rate graph appears as a blue line.
Default : Off
MHR Overrides FHR
The MHR Overrides FHR parameter activates the condition whereby the FHR probe picks-up the
maternal heart beat rate, when set to “on”.
Default : Off
MSPO
2
Printing Frequency
The MSPO
2
Printing Frequency parameter activates printing of the maternal SpO
2
value on the strip
at the specified frequency selected. Printing occurs only if there is a connected SpO
2
probe.
Frequency selections include, in minutes: 1, 2, 3, 5, 10, 15, 30, 60, 90
Default : 10 minutes