Bull NovaScale R460 E2, User Manual, Page: 60 / 490

2-26 General Description
The message "<F12> to Network" prompts you network booting (PXE boot). If you press F12 , the POST searches
for boot device on network.
4.
If the POST detects the optional add-in card, it display the message prompting you to launch the add-in card BIOS
configuration utility. (Ignore the message. POST will automatically proceed a few seconds later.)
Refer to the manual that comes with the optional add-in card for detail.
5.
If you set a password using the BIOS setup utility, SETUP, the password entry screen appears upon successful
completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable the server to boot. In such a
case, turn off the power and wait about 30 seconds before turning on to boot the server.
IMPORTANT:
Do not set a password before installing an OS.
6.
The OS starts when POST completes.
POST Error Messages
When POST detects an error, it displays an error message on the display unit screen. See Chapter 8 for POST error codes.
IMPORTANT:
Take a note on the messages displayed before consulting with your service
representative. Alarm messages are useful information for maintenance.
Power Off
Follow the procedure below to power off the server. If the power cord of the server is connected to a UPS, refer to the manual
that comes with the UPS or the manual for the application that controls the UPS.
IMPORTANT:
Always allow POST to complete before turning off the server.
1.
Shut down the OS.
2.
Press the POWER switch on the front of the server.
The POWER LED goes off.
3.
Power off peripheral devices.
NOTE:
The standby feature of Windows Server is not available. Do not select "Standby" in
Windows shutdown menu.