Bull NovaScale R460 E2, User Manual, Page: 282 / 490

8-28 Troubleshooting
Problems with ExpressBuilder
When the server is not booted from the ExpressBuilder DVD, check the following:
‰
Did you set the ExpressBuilder during POST and restart the server?
→
If you do not set the ExpressBuilder during POST and restart the server, an error message will appear or the
OS will boot.
‰
Is BIOS configuration correct?
→
The boot device order may be specified with the BIOS SETUP utility of the server. Use the BIOS SETUP
utility to change the boot device order to boot the system from the optical disk drive first.
<Menu to check: [Boot]>
‰
If [Os installation ***default***] is selected at Boot selection screen, following message is displayed.
After this message appears, check the error and take the appropriate corrective action according to the message
listed in the table below.
Message Cause
This EXPRESSBUILDER version was not
designed for this computer.
Insert the correct version and click [OK]. (When
you click [OK], the computer reboots.) This ExpressBuilder version is not designed for this
server.
Execute the ExpressBuilder on the compliant server.
EXPRESSBUILDER could not get the hardware
parameters written in this motherboard.
This version is not designed for this computer or
the motherboard may be broken. (When you
click [OK], the computer reboots.)
The hardware parameters written in this
motherboard are incorrect.
This version is not designed for this computer or
the motherboard may be broken. This message is shown when ExpressBuilder could not
find system-specific information because of mother
board exchange and so on.