Bull NovaScale R460 E2, User Manual, Page: 258 / 490

8-4 Troubleshooting
POST Error Messages
When POST detects an error, it displays an error message on the display unit screen. The following table lists error messages
and actions to take.
IMPORTANT:
Take a note on the messages displayed before consulting with your service
representative. Alarm messages are useful information for maintenance.
Error
code Error message
Recommended Action
0200 Failure Fixed Disk. Contact your service representative.
0210 Stuck Key. Disconnect the keyboard and connect it again.
0211 Keyboard error Disconnect the keyboard and connect it again. If the error cannot be
corrected, contact your service representative.
0213 Keyboard locked - Unlock key switch. Release the lock of the key switch. If the error cannot be corrected in
spite of the release of the lock, contact your service representative.
0220
Monitor type does not match CMOS - Run
SETUP. Start the SETUP. If the error cannot be corrected in spite of the start of
SETUP, contact your service representative.
0230 System RAM Failed at offset.
0231 Shadow Ram Failed at offset.
0232 Extended RAM Failed at address line.
Contact your service representative.
0250 System battery is dead - Replace and run
SETUP. Contact your service representative to replace the battery. (After
restarting the computer, start the SETUP to provide the setting again.)
0251 System CMOS checksum bad - Default
configuration used. The default values have just been set. Start the SETUP to provide the
setting again. If the error cannot be corrected, contact your service
representative.
0252 Password checksum bad - Passwords
cleared. The password has just been cleared. Start the SETUP to provide the
setting again.
0260 System timer error.
0270 Real time clock error.
0271 Check date and time setting.
Start the SETUP to set the date and time again. If the same error
occurs successively in spite of the resetting, contact your service
representative.
0280 Previous boot incomplete - Default
configuration used. Start the SETUP to provide the setting again.
0281 Memory size found by POST differed from
EISA CMOS. Initialize EISA CMOS.
02D0 System cache error - Cache disabled. The cache cannot be used. Contact your service representative.
02D1 System Memory exceeds the CPU's caching
limit.
02F4 EISA CMOS not write able.
02F5 DMA Test Failed.
02F6 Software NMI Failed.
02F7 Fail-safe Timer NMI Failed.
Contact your service representative.
0B22 Processors are installed out of order. Request the maintenance to replace the CPU.
0B28 Unsupported CPU detected on CPU socket
1.
0B29 Unsupported CPU detected on CPU socket
2.
Make sure that the server supports the CPU. If you are not sure,
contact your service representative to request the maintenance.
0B42 Resource Conflict
0B43 Warning: IRQ not configured
0B45 System configuration Data Write Error
Contact your service representative.
0B60 CPU1_DIMM1 has been disabled
0B61 CPU1_DIMM2 has been disabled
0B62 CPU1_DIMM3 has been disabled
0B63 CPU1_DIMM4 has been disabled
0B64 CPU1_DIMM5 has been disabled
0B65 CPU1_DIMM6 has been disabled
0B66 CPU2_DIMM1 has been disabled
0B67 CPU2_DIMM2 has been disabled
0B68 CPU2_DIMM3 has been disabled
0B69 CPU2_DIMM4 has been disabled
Contact your service representative.