Bull NovaScale R460 E2, User Manual, Page: 254 / 490

7-10 Maintenance
RELOCATING/STORING THE SERVER
Follow the procedure below to relocate or store the server:
CAUTION
Observe the following instructions to use the server safely. Failure to follow these instructions may cause
a fire, personal injury, or property damage. See pages 1-3 to 1-13 for details.
„
Never attempt to lift the server only by yourself.
„
Do not install the server in any place other than specified.
„
Do not connect/disconnect any interface cable with the power cord of the server plugged to a power
source.
IMPORTANT:
„
If the server needs to be relocated/stored due to a change in the floor layout to a great extent,
contact the service representative.
„
Make sure to make a backup copy of your valuable data in the hard disk drive, if any.
„
Make sure not to apply a shock to hard disk drives to relocated the server if the contains any.
1.
Take a media out of the server, if any.
2.
Power off the server (the POWER/SLEEP LED goes off).
3.
Unplug the power cord of the server from a power outlet.
4.
Remove all the cables from the server.
5.
Hold the server by its bottom with at least three persons to carry the server.
IMPORTANT:
Do not hold the front door to lift the server. The front door may be disengaged
from the server, causing personal injury.
6.
Protect the server with the shock-absorbing materials, and pack it securely.