Bull NovaScale R460 E2, User Manual, Page: 24 / 490

1-6 Notes on Using Your Server
Rack
CAUTION
Do not carry or install the server only by a single person.
More than one person is required to carry or install the rack. Failure to follow this instruction may cause
the rack to fall to result in personal injury and/or breakages of surrounding devices. In particular, a high
rack (such as 44U rack) is unstable if it is not fixed by stabilizers. More than one person must always carry
or install the rack while they support it.
Do not install the server so that the load may be concentrated on a specific point.
Install stabilizers on the rack so that the total load of the rack and devices mounted on the rack is not
concentrated on a singe point or join more than one rack with each other to distribute the load. Failure to
follow this instruction may cause the rack to fall to result in personal injury.
Do not install components on the server only by a single person.
More than one person is required to install parts including the doors and trays for the rack. Failure to
follow this instruction may cause some parts to fall to be broken and/or to result in personal injury.
Insert hinges completely.
When installing the rack door, make sure that hinge pins at top and bottom of the door are completely
inserted into the rack. Failure to follow this instruction may cause the door to fall to be broken and/or to
result in personal injury.
Anchor the equipment rack.
The equipment rack must be anchored to an unmovable support to prevent it from falling over when one
or more servers are extended in front of it on slide assemblies. The anchors must be able to withstand a
force of up to 113 kg (250 lbs.) You must also consider the weight of any other device installed in the rack.
Do not leave more than one device being pulled out from the rack.
Pulling out more than one device from the rack may cause the rack to be fallen. Only pull out a single
device from the rack at a time.
Do not provide the wiring for the server to exceed the rating of the power supply.
To prevent burns, fires, and device damages, the power supplied to the power supply in the rack shall not
exceed the rating load of the power branch circuit. Contact your electric constructor or the local power
company for the requirements on the wiring and installation of electric facilities.