Bull Cedoc NovaScale R440 E2, User Manual, Page: 342 / 552

8-34 Troubleshooting
Problems with Express Setup
The system partition is created with a size smaller than the specified value.
→
In Express Setup, there are some cases that the system partition is created with a size about 8MB smaller than
the specified size.
It is not a problem when operating the system.
The following message appeared when you tried to install Express Setup on a hard disk drive that has a smaller
capacity than the specified partition size:
The creating of the partition was failed.
The process can not be continued. The process was stopped.
O K
→
Cannot continue the setup.
Specify a partition size smaller than the capacity of the connected hard disk drive, and then retry the setup.
Specified to join the Domain, but the system is installed as Workgroup.
→
When the setup fails to join the Domain during the installation, it will install the system as Workgroup. Open
[System] in Control Panel to specify joining the Domain.
Unable to specify the details of Network adapter.
→
In Express Setup, you cannot specify the details of the Network adapter. Specify them from the Control Panel
after starting Windows.
The following message appeared when you tried to install:
Windows Server 2008 by Express Setup using RAID Controller.
Windows cannot find a system volume that meets requirements for installation
→
See "RAID Configuration (Chapter 4)" to create RAID.
Or, see "Creating a new RAID using RAID Controller (Page 5-70)" to configure RAID by ExpressBuilder
beforehand, and perform Express Setup.
In this case, select [Skip the logical drive creation] in the [Enter RAID settings] (Step 4) screen of Express
Setup.