Bull Cedoc NovaScale R440 E2, User Manual, Page: 312 / 552

8-4 Troubleshooting
POST Error Messages
When POST detects an error, it displays an error message on the display unit screen. The following table lists error messages
and actions to take.
IMPORTANT:
Take a note of the messages displayed before contacting your service
representative. Alarm messages are useful information for maintenance.
Error
code
Error message Recommended Action
0200 Failure Fixed Disk. Contact your service representative.
0210 Stuck Key. Disconnect the keyboard and connect it
again.
0211 Keyboard error
Disconnect the keyboard and connect it
again. If the error cannot be corrected,
contact your service representative.
0213 Keyboard locked - Unlock key switch. Release the lock of the key switch. If the
error cannot be corrected in spite of the
release of the lock, contact your service
representative.
0220 Monitor type does not match CMOS - Run
SETUP. Start the SETUP. If the error cannot be
corrected in spite of the start of SETUP,
contact your service representative.
0230 System RAM Failed at offset.
0231 Shadow Ram Failed at offset.
0232 Extended RAM Failed at address line.
Contact your service representative.
0250 System battery is dead - Replace and run
SETUP. Contact your service representative to
replace the battery. (After restarting the
computer, start the SETUP to provide the
setting again.)
0251
System CMOS checksum bad - Default
configuration used. The default values have just been set.
Start the SETUP to provide the setting
again. If the error cannot be corrected,
contact your service representative.
0252 Password checksum bad - Passwords
cleared. The password has just been cleared. Start
the SETUP to provide the setting again.
0260 System timer error.
0270 Real time clock error.
0271 Check date and time setting.
Start the SETUP to set the date and time
again. If the same error occurs
successively in spite of the resetting,
contact your service representative.
0280 Previous boot incomplete - Default
configuration used. Start the SETUP to provide the setting
again.
0281 Memory size found by POST differed from
EISA CMOS. Initialize EISA CMOS.
02D0 System cache error - Cache disabled. The cache cannot be used. Contact your
service representative.