Bull Cedoc NovaScale R440 E2, User Manual, Page: 157 / 552

Configuring Your Server 4-63
Virtual Drives
When you click [Virtual Drives] on the WebBIOS Top Menu, the screen for operating the virtual drive that has already been
configured is displayed.
Fast Initialize: Clears the top area of the virtual drive being selected in the List of virtual
drives box.
Slow Initialize: Clears whole area of the virtual drive being selected in the List of virtual
drives box.
Check Consistency: Checks consistency in the whole area of the virtual drive being selected in
the List of virtual drives box.
If inconsistency is found, correct it.
Properties:
Displays the properties of the virtual drive being selected in the List of
virtual drives box.
Set Boot Drive
(Current =XX):
Default: NONE Selects a virtual drive to start the operating system.
If the system contains several virtual drives and you want to start the
operating system from the virtual drive other than VD0, you need to specify
the boot drive manually as shown below. Use the default setting in any
other cases.
[Setting procedure]
1. Select a virtual drive you want to start operating system from the
List of
virtual drives box.
2. Put a checkmark on "Set Boot Drive (Current =XX)".
3. Click [Go].
IMPORTANT:
„
If no virtual drive exists, the List of virtual drives box will be blank. Use this menu only when
a virtual drive exists.
„
Even the "Set Boot Drive" is properly specified, the operating system may fail to start due to
Boot Priority specified in BIOS SETUP of the server.
„
Inconsistency may be detected at the first Check Consistency performed after the virtual drive
was configured.
List of VDs