The NYCe 4000 modules may only be used with the accessories
and parts specified in this documentation. If a component has not
been specifically named, then it may neither be installed nor
connected.
Operation is only permitted in the specified configurations and
combinations of components using the software and firmware as
specified in the relevant function descriptions.
Every NYCe 4000 module must be programmed before starting it
up, making it possible for the motor to execute the specific
functions of an application. The NYCe 4000 modules are
designed for use in single or multiple-axis drive and control
applications.
To ensure an application-specific use, the NYCe 4000 modules are available
with differing drive power and different interfaces.
Typical application of NYCe 4000 modules is in machines requiring high-
precision motion control.
The NYCe 4000 modules may only be operated under the assembly,
installation and ambient conditions as described in this documentation
(temperature, system of protection, humidity, EMC requirements, etc.) and in
the position specified.
3.3
Inappropriate Use
Using the NYCe 4000 modules outside of the above-referenced areas of
application or under operating conditions other than described in the
documentation, technical data and specifications is defined as "inappropriate
use".
NYCe 4000 modules may not be used
●
if they are subject to operating conditions that do not meet the specified
ambient conditions. This includes, for example, operation under water,
in case of extreme temperature fluctuations or extremely high maximum
temperatures,
or
●
if Rexroth has not specifically released them for that intended purpose.
Make sure you carefully follow the specifications outlined in
chapter 2.3 "General Information" on page 9
.
3.4
Acceptance tests and approvals
3.4.1
Introduction
Declarations of conformity confirm that the components comply with valid EN
standards and EC directives. If required, our sales representative can provide
you with the declarations of conformity for our components.
3.4.2
Low voltage directive
These components correspond to the following standard.
●
IEC 61010-1:2010
20/233
Important Directions for Use
NYCe 4000 Multi-axis motion control system Hardware Sys‐
tem Manual
Bosch Rexroth AG R911337671_Edition 18
