Bosch R911172904, Hardware Manual

Page: 220 / 243

15 NYCe 4000 Hardware Glossary
A
C
D
E
F
}
B
G
Fig. 15-1: NYCe 4000 components
Component Name Type number Remarks
A module holder - -
B base plate - -
C system
backplane
- Interconnect between MCU module
and other NYCe 4000 motion node
modules.
D I/O backplane - Connection panel between
NYCe 4000 drive modules and motor
and I/O headers.
E MCU NY4110,
NY4112,
NY4114
Motion Control Unit. This is not a
"drive" but actually a unit, because it
can be used ‘stand-alone’. If an MCU
is put in a system housing, you can
communicate with it.
F drive module NY41xy,
where xy = 20,
25, 30, 40, 50
These components are not "units"
because they cannot be used ‘stand-
alone’. If only a drive module is put in
a system housing, you cannot do
any useful work with it.
Drive module can also be I/O
module, power supply module, or
SERCOS III Master module.
G header - For clear identification the
‘connector’ at the end of a cable is
called "plug" and the ‘connector’ on a
[system, I/O] backplane is called
"header".
Tab. 15-1: Identification names of the components
NYCe 4000 Multi-axis motion control system Hardware Sys‐
tem Manual
211/233
NYCe 4000 Hardware Glossary
R911337671_Edition 18 Bosch Rexroth AG