Bomag BW 219 DH-4, Service Training

Page: 126 / 1290

6.1
Installation électrique ESX
BOMAG 126 008 924 62
Service Training WZ-4 from Version DH
Version/Status: V3.60#00 / 20.07.12
Functions of ESX Control
Page 20 of 97
Author: Schöfl/ TE/TES
5.1.1 Procedure for initial commissioning of a control
•
The control has been installed into the machine.
•
Switch the ignition on. Approx. 4 seconds after switching on the letters
C O D E
are displayed for a
period of approx. 3 seconds. After this the display changes and shows code
7000
.
•
Use the Arrow Up or Arrow Down keys to select the correct machine code from the list of codes.
•
Confirm the selection with the Arrow Right key.
•
After a period of approx. 7 seconds the adjusted machine code, e.g.
7 2 1 2
is displayed for approx.
3 seconds. The new parameters are loaded according to the machine type setting. Do not switch
the ignition off during this time!
•
After this switch the ignition off and on again to accept the configuration.
•
After this the normal display will appear again.
5.1.2 Procedure for changing a machine type
•
Enter code number
9 9 9 9
(activation of service mode)
•
Enter code number
7 0 1 0
. This code number activates the function “Adjusting machine type”.
The display module now permanently shows the code
7 2 0 0
.
•
Select the machine code from the table above and confirm it with the Arrow Right key. After operat-
ing the Arrow Right key the control switches automatically off and on again.
•
After a period of approx. 7 seconds the adjusted machine code, e.g.
7 2 1 2
is displayed for approx.
3 seconds. The new parameters are loaded according to the machine type setting. Do not switch
the ignition off during this time!
•
After this switch the ignition off and on again to accept the configuration.
•
After this the normal display will appear again.
5.2 Driving against the closed brake
After entering the code number
0 5 0 0
the brake will not be released. If the travel lever is in this condi-
tion shifted out of the brake gate and moved to any travel direction, the travel pumps will be triggered
according to the chosen travel direction. At the same time a warning (fault code
0 5 0 0
) appears on
the display and the warning buzzer is triggered, in order to keep the operator informed about the condi-
tion. The brake control light in the LC-display remains activated.
In order to terminate this function and to release the brake you must either enter code number
0 5 0 1
or switch the ignition off. After entering code number
0 5 0 1
the function is aborted and
OK
is dis-
played as confirmation for 5 seconds. After this the code needs to be entered again.
This function can only be activated / deactivated when the travel lever is
locked in the brake gate. (
Æ
Input mode)
Note
L
A machine must not be operated with a wrong type setting, because in
such a case the correct function of the control cannot be assured!
New controls are delivered with a default machine type setting
7 2 0 0
.
This does not enable to drive or steer the machine. It only serves the pur-
pose of commissioning.
Note
L