Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 79 / 216

79
Kaleido-X (7RU)
Installation & Service Manual
9 On the System Configuration page, change the Frame IP Address , the System name ,
and the IP addresses of Output A , B and C so that they are unique to Frame B (i.e.
different from those of Frame A ).
10 Click Save , and then click Apply settings in the sidebar.
Frame B automatically reboots (this should take about two minutes).
11 When Frame B has finished rebooting, open XAdmin using the new Frame IP Address
you assigned in step 9 .
12 Verify that Frame B is working correctly, and that there are no errors reported on the
Status and Options page.
13 Reinsert the KXO cards in slots A and B (if applicable).
14 Power up Frame A (this should take about two minutes).
15 When Frame A has finished rebooting, open XAdmin (using the IP address of the
expansion system, which is now, effectively, the IP address of Frame A ).
16 On the System Configuration page, clear the Enable expansion check box.
17 Click Save , and then click Apply settings in the sidebar.
Frame A automatically reboots (this should take about two to three minutes).
18 Open XAdmin (again, using the IP address of the expansion system).
19 Verify that Frame A is working correctly, and that there are no errors reported on the
Status and Options page.
At this point, the two frames are operating independently, but each with its own copy
of the expansion system database. You can now:
• rejoin the two frames in an expansion configuration (see Expanding New Kaleido-X
Frames , on page 50)
or
• modify/replace the databases so that they correspond to the standalone operation
of the frames (refer to the procedures described in If you have existing backup
copies of the standalone frames , on page 74).
To split an expansion system when only Frame B is running (version 4.10 or later)
1 Make sure that Frame A is powered down.
2 On Frame B , slide the front panels of the KXO cards partially out of slots A and B (if
present), leaving the master KXO card in slot C inserted.
3 Open XAdmin using the IP address of the expansion system.
4 On the System Configuration page, clear the Enable expansion check box.
The IP addresses associated with the KXO cards in Frame B disappear.
Note:
If the Enable expansion check box is already unchecked, select it,
click Save , and then clear the check box again.