Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 159 / 216

159
Kaleido-X (7RU)
Installation & Service Manual
Loading a Layout
If your system was configured prior to shipment, a layout already appears on all displays.
Otherwise, a gray screen will appear with the following message in the middle:
No layout
has been assigned to this room. Please load a layout.
To load a layout on the monitor wall
• If you have configured a Kaleido-RCP2 (see Configuring the Kaleido-RCP2 , on
page 142), press any of the LAYOUT PRESETS buttons to load a predefined layout on the
monitor wall.
• Alternatively, connect a mouse directly to one of the USB ports on your Kaleido-X
output cards.
a Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a
monitor), and then click Load layout on the shortcut menu.

A layout browser appears on the displays associated with the current room. By
default, each room is associated with one output card. Each default layout is pre-
configured to show 16 video streams for each input card.
b Select the layout you wish to load from the list of available layouts for this room,
and then click OK .

The selected layout appears on the room displays.
Customizing Layouts, Logical Sources, and other Kaleido-IP Elements
Refer to the Kaleido Software User Manual to learn how to customize the Kaleido-IP to suit
your specific needs. See Related Documentation , on page 15.
Verifying the Audio Bridge Terminal
To verify that the ABT is functioning normally:
• Inspect the ACTIVITY and front panel LEDs on the unit to make sure there are no error
conditions:
The ACTIVITY indicator is located on the right-hand side of the rear panel. This LED
reports the status of the Ethernet connection as indicated in the table below.
Two LEDs are visible on the front panel, one for each power supply. When lit, they both
indicate the same status.
When the ABT is powered up, all three LEDs will be orange until the boot sequence is
terminated. This is a visual indicator that the LEDs are functioning properly.
Note:
To access other layouts, press the LOAD button. To assign a layout to
a preset button, press and hold the button for more than six seconds while
the desired layout is showing on the monitor wall.
ACTIVITY Indicator on Rear Panel Power-Supply LEDs on Front Panel
Color Status Color Status
Off No link detected Green Normal
Green Normal (good link) Flashing green Normal, rebooting