Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 67 / 216

67
Kaleido-X (7RU)
Installation & Service Manual
9 Power up both frames.
Alarms may appear in the dashboard (see below), and, in some cases, you may see
flashing LEDs on the KXO cards in
Frame B . This is normal.
Once the frames have rebooted, wait 5 minutes (this allows some important internal
processing to take place) and then continue with the procedure
1
as described in Part B
— XAdmin Settings below.
Frame B will not boot completely at this stage. This is normal.
Part B — XAdmin Settings
At this point, Frame A should be up and running, with all input, output, network and serial
cables in position, and Frame B should not be rebooted. Prior to expansion, each frame and
all KXO cards normally have unique IP addresses. You will now use XAdmin to:
• specify one IP address for the expanded system
• verify that there are no conflicts among the IP addresses of the KXO cards
• make sure that all IP addresses are on the same subnet
1 Open XAdmin for Frame A (see Opening XAdmin, on page 114 ).
2 On the Status and Options page, select Enable expansion .
1.Even if, as in some cases, Frame B does not completely reboot.
Connect EXP LINK 1 on FRAME A
to EXP LINK 1 on FRAME B
Connect EXP LINK 2 on FRAME B
to EXP LINK 2 on FRAME A