4-40 Operator’s Manual
110017276EN Rev. B
4 Detailed Reference
Anterior Vitrectomy Function
The
Stellaris® PC
Vision Enhancement System supports a pneumatic vitrectomy cutter, which uses pressurized
air to drive the guillotine-type vitrectomy cutter. The Advanced Vacuum system provides aspiration to draw the
vitreous material into the port, where it is then cut and aspirated through the flexible tubing into the disposable
collection container.
Anterior Vitrectomy Cutter Modes
The Advanced Vacuum System provides two vitrectomy cutter modes:
Fixed Cut
Pneumatic cutter: The control may be adjusted to provide a fixed cutting speed from 30 to 5000 cuts per minute.
Dual Linear Cut
Pneumatic cutter: The control may be adjusted to provide a linear cutting speed from 30 to 5000 cuts per
minute. The footpedal yaw is used to achieve dual linear function.
The cut rate may be adjusted from 30 to 5000 cpm, with increments as shown in the table below, or to any
specific value using the keypad.
Range
Step Size
30 to 100 cpm
10 cpm
100 to 1000 cpm
50 cpm
1000 to 5000 cpm
100 cpm
Planned Anterior Vitrectomy Setup
WARNING:
For optimum aspiration and reflux performance, the patient’s eye level must be at the same
level as (no more than 7 cm [3 in.] from) the Stellaris® PC Vision Enhancement System
aspiration port. Failure to follow this procedure may result in serious and permanent patient
injury.
Note:
Specific instructions for cleaning and sterilization included with the handpiece or accessory
take precedence over these instructions.
1.
Turn Power on.
2.
Press any button on the Foot Control and wait until the ready light turns solid green, indicating wireless
communication has been established.
3.
Select
Surgeon’s Name
and select
Confirm
.
Summary of Contents for STELLARIS PC
