Bausch & Lomb STELLARIS PC, Operator'S Manual

Page: 275 / 352

Operator’s Manual 6-17 110017276EN Rev. B
6 Troubleshooting
ID Type Text Message Suggested Action(s)
WFC20 Warning
The system has lost communications
with the Foot Control.
SG99 Check the cable connection.
SG34 Replace the Foot Control with
another Foot Control using the wired cable
connection to the system.
SG04 Call your product service
representative if this problem persists.
Foot Control Receiver Module Messages
ID Type Text Message Suggested Action(s)
WFR01 Warning
The Foot Control receiver was not
detected in the system. Surgical mode is
not available.
SG01 Call your product service
representative.
WFR02 Warning
The Foot Control receiver software
version is not compatible with this
software version. Surgical mode is not
available.
SG02 Call your product service
representative. A compatible software
version must be downloaded.
WFR03 Warning
The Foot Control receiver has failed
to respond to a settings command. The
module settings have been re-sent to the
module.
SG04 Call your product service
representative if this problem persists.
WFR04 Warning
The Foot Control receiver has reset. The
module settings have been re-sent to the
module.
SG04 Call your product service
representative if this problem persists.
Internal Application Messages
The system requires restarting due to an internal error, please perform the following:
1. Select Close to initiate system shutdown.
2. If system does not shutdown after 30 seconds, power off the system by pressing and holding the power
button at the front panel.
3. Restart system after one minute.
Call your product service representative if this problem persists.