Operator’s Manual 4-25
110017276EN Rev. B
4 Detailed Reference
Figure 4.17. Viscous Fluid Injection Setup.
1. Viscous Fluid Port. 2. Air Tubing Connector. 3. Coupler. 4. Piston. 5. Syringe with Silicone Oil.
6. Syringe Cap. 7. 19g Injection Cannula (for injection). 8. 19g Extraction Cannula.
Viscous Fluid Injection Operation Modes
Fixed Fluid Injection
The footpedal is used to control the injection with a pre-programmed fixed pressure. The pressure level is set
using the spin buttons on the touch screen.
Linear Fluid Injection
Control of linear fluid injection is via the footpedal. The injection pressure increases proportional to footpedal
travel from the minimum programmed setting to the maximum programmed setting. The minimum and
maximum pressure levels are set using the touch screen.
Dual/Yaw Vac (Linear Fluid Injection, Linear Vacuum)
Linear fluid injection is actuated by depressing the footpedal. Linear aspiration through the left aspiration line is
actuated by an outward yaw movement of the center footpedal. The minimum and maximum pressure levels are
set using the touch screen.
Extraction
1.
Open a CX5710 disposable pack and place contents on a sterile surface.
2.
Connect the locking air connector on the tubing set to the
Stellaris® PC
system (Top right connector,
Figure 1.22 .)
Summary of Contents for STELLARIS PC
