Bausch & Lomb STELLARIS PC, Operator'S Manual

Page: 40 / 352

1-30 Operator’s Manual 110017276EN Rev. B
1 Getting Started
1.10. Moving Your System to Another Location
WARNING: Do not transport or move your system from room to room or up an inclination unless you
have followed the steps below.
This unit is designed to provide mobility within the environment of the operating room.
Care must be taken as to avoid sloped floors greater than 5 degrees angle during use.
Before transporting the unit from room to room or for any more extensive moving, follow the basic safety
instructions:
1. Power down normally by selecting “Shut Down” from the end of case
screen or pressing and holding the front button for at least 8 seconds,
ensuring the IV pole is fully retracted.
2. Remove any objects from mat on top of unit.
3. Depressurize the compressed air supply that feeds your unit.
4. Disconnect the pneumatic air hose from the lower left corner (facing the
rear end of the unit)
5. Store the tray all the way in the unit’s tray receptacle.
6. Fully close the front drawer.
7. Roll the power cord in its proper hooks at the rear end of the unit.
8. Place the foot control on its dedicated hook, at the rear end of unit.
9. Remove the bottles and tube sets from the unit’s pole hanger and store
separately from the unit.
10. Make sure no objects such as air hose, electrical cord, video cables, etc... lie in the moving path.
11. Disengage the front brake lever.
12. Always maneuver the unit using the handle bar designed for this purpose.
Note:
Do not store anything on top of the system, and do not pull the system by the IV pole.