3Com Router Command Reference Guide — V1.00
v3
:
Enable SNMPv3 operations.
all
:
Enable operations of SNMP of all versions.
Description
Using the
snmp-agent sys-info version
command, you can configure the version
that a network management station (NMS) can use to manage the SNMP agent.
Using the
undo snmp-agent sys-info version
command, you can restore the NMS
to use the default version to manage the agent.
By default, SNMPv3 operations are enabled.
Since SNMPv3 provides higher security, the system only enables the NMS to perform
SNMPv3 operations on the SNMP agent by default. You can use this command to
enable the NMS to perform SNMPv1 or SNMPv2 .
For related commands, see
snmp-agent, snmp-agent community, snmp-agent
group, snmp-agent mib-view
.
Example
# Enable the NMS to perform SNMPv1 operations on the SNMP agent.
[3Com]
snmp-agent sys-info version v1
3.1.19 snmp-agent target-host
Syntax
snmp-agent target-host trap address host_address securityname
name
[
port
port
] [
parameters
{
v1
|
v2c
|
v3
{
authentication
|
noauthentication
|
privacy
} } ]
undo snmp-agent target-host trap address host_address securityname
name
[
port
port
]
View
System view
Parameter
address host_address
:
IP address of the host receiving SNMP Trap messages.
port port:
The UDP port number of host receiving SNMP Trap messages, ranging
form 0 to 65535.
parameters
: Set the version of SNMP used in Trap messages.
56
Summary of Contents for 3C13612
Page 1: ...3Com Router Command Reference Guide V1 00 http www 3com com Part No Published August 2003 ...
Page 199: ...3Com Router Command Reference Guide V1 00 8 1 36 reset stp statistics 167 6 ...
Page 456: ...3Com Router Command Reference Guide V1 00 Quidway reset ipx statistics 96 ...
Page 493: ...Routing Protocol 6 1 10 ip policy route policy 137 5 ...
