Security
3.1.8 firewall default
Syntax
firewall default
{
permit
|
deny
}
View
System view
Parameter
permit
: Default filter attribute is “permit”.
deny
: Default filter attribute is “deny”.
Description
Using the
firewall default
command, you can configure the default filter mode when
there is no matching access rule.
By default, Packets are permitted to pass the firewall in the case that the firewall is
enabled.
If none of the access rules applied at the interface can judge if a packet is permitted
or denied, the default filter attribute will function. If the default filter attribute is
“Permitted”, then the packet can pass, otherwise it will be dropped.
Example
# Configure the default filter attribute to “Permitted”.
[3Com]
firewall default permit
3.1.9 firewall packet-filter
Syntax
firewall packet-filter
{
acl-number
}
{ inbound | outbound }
undo firewall packet-filter
{
acl-number
}
{ inbound | outbound }
View
Interface view
35
Summary of Contents for 3C13612
Page 1: ...3Com Router Command Reference Guide V1 00 http www 3com com Part No Published August 2003 ...
Page 199: ...3Com Router Command Reference Guide V1 00 8 1 36 reset stp statistics 167 6 ...
Page 456: ...3Com Router Command Reference Guide V1 00 Quidway reset ipx statistics 96 ...
Page 493: ...Routing Protocol 6 1 10 ip policy route policy 137 5 ...
