Interface Management
3.1.11 invert transmit-clock
Syntax
invert
transmit-clock
undo invert transmit-clock
View
Serial interface view
Parameter
None
Description
Using the
invert transmit-clock
command, you can enable the invert transmit clock
on the synchronous serial interface at the DTE side. Using the
undo invert
transmit-clock
command, you can disable the invert transmit-clock.
By default, Invert transmit-clock disabled when the synchronous serial interface acts
as the DTE.
In some circumstances, the transmit clock on the serial interface of the DTE side is
inverted to eliminate the delay for half a clock cycle. This command is only valid for
some clock signals provided by some special DCE. The transmit clock should not be
inverted for normal applications.
For related commands, see
physical-mode
,
clock
.
Example
# Invert the transmit clock on the DTE side serial interface.
[3Com-Serial0]
invert transmit-clock
3.1.12 loopback (Serial Interface)
Syntax
loopback
undo loopback
27
Summary of Contents for 3C13612
Page 1: ...3Com Router Command Reference Guide V1 00 http www 3com com Part No Published August 2003 ...
Page 199: ...3Com Router Command Reference Guide V1 00 8 1 36 reset stp statistics 167 6 ...
Page 456: ...3Com Router Command Reference Guide V1 00 Quidway reset ipx statistics 96 ...
Page 493: ...Routing Protocol 6 1 10 ip policy route policy 137 5 ...
