Zontes ZT250-R, Руководство по обслуживанию

Страница: 45 / 76

7-FRONT FORK COMPONENT 44
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224100-037000 Grade 0 flame retardant tie (black 3.6×295) 1
2 1224100-044000 Wheel speed sensor clamp 3
3 1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc) 1
4 1251100-080094 Non-standard bolt M8×37 (environmental color zinc) 2
5 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 2
6 1224200-127000 ZT310
－
T front wheel WSS wire clip
1
7 1184200-045000 DF30 wheel speed sensor 1
8 1251100-102000 Non-standard bolt M6×16 (stainless steel) 4
9 1244100-037000 φ12×φ8.5×2.5 Circular buffer 4
10 1274100-018000 ZT250-S Muffler anti-hot plate bushing 4
4044201-078051
ZT310
－
R front mudguard(dark bright gray/gray sticker/ABS)
4044201-078021
ZT310
－
R front fender (bright black / sticker gray / ABS)
12 1274200-035194 Front fender liner ZT310 (black zinc) 2
13 1274200-038000 ZT310
－
X Front fender front oil outlet pipe fixed seat
1
14 1250402-001091
GB12615 φ3×10 Rivet
1
PROCEDURE:
●
Wheel speed sensor
Pull out the plug of the wheel speed sensor (7); cut off the belting (1); then remove 3 pcs clamp (2).Pull out the
sensor cable from the clip(6) and remove the bolts(3) abd bolts(5) on the bottom, remove the sensor(7).
●
Front disc brake caliper
Remove the bolts (3) and (4) so that the caliper will hang down naturally. It is forbidden to invert the caliper to
prevent the air from entering and causing the brake to fail.Remove thebolt(5) on the clip(6) and take out of it.
●
Front mudguard
Hold the front mud plate (11) with your hand and then remove the 4 bolts (8) and remove the bushing (10) and
cushion rubber (9). Remove the front mudguard (11). The inside of the front mudguard can be protected with
reticle or double-sided tape around the rivet (14), then the rivet is ground off with a small sander, and then the
rivet (14) and the fixing seat (13) are removed.
●
Front mudguard liner
Remove the bushing(12) with a 10mm open end wrench.
CAUTION:
●
The motorcycle support should be fixed during disassembly to prevent accidents caused by incline.
●
Remove the tube clamps, sensor clamps should pay attention to strength.
●
Pay attention to the strength when disassembling the front mud plate to prevent scratching the paint surface.
After-sale
11 1
FIG.9 FRONT FORK
COMPONENT
Front mud board & wheel speed sensor component