Zontes ZT250-R, Руководство по обслуживанию

Страница: 53 / 76

7-FRONT FORK COMPONENT 52
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224100-025000 ZT250-SM8 Bolt decoration buckle 4
2 1250205-023000 GB70.1 Hexagon M8×35 (environmental color zinc) 10
3 1134200-005000 ZT310
－
R press block of handle bar(home
－
made)
1
4 1134200-003000 ZT310
－
R handle bar
1
5 1251300-045000 ZT250-S Upper plate decorative nut (chrome) 1
6 1251500-050000 ZT250-S Upper plate gasket φ18.5×φ39×1 (chrome) 1
7 1114200-027000 ZT310
－
R front left shock absorber(improved)
1
8 1114200-028000 ZT310
－
R front right shock absorber(improved)
1
9 1174100-001000 ZT250
－
S reflection light
2 after-sales
10 1251100-121093 Non
－
standard bolt M6×25 (environmental color)
2
11 1250501-007093
GB93φ8(color zinc)
2
1184200-034000 ZT310
－
R electronic faucet lock (DC)
Stop selling
1184200-156000 ZT250
－
R Faucet Lock (Electromagnetic Drive / Line
Length 150) Assembly
New
Direction handle, upper plate assembly
12 1
Old New
Includede
reflection light
FIG.17 FRONT FORK
COMPONENT
PROCEDURE:
●
Handlebar assembly
Pick up the decorative buckle(1) with a razor blade, hold the direction handle(4) with one hand, remove the bolt(2) with a
hexagonal tool in one hand, remove the pressure block(3), the right pad block(5), the left pad block(6), and finally remove
the handle(4).
●
Uplink board assembly
Locate the faucet lock plug and remove it; remove the nut
⑸
and remove the shims
⑹
. Remove the upper plate bolts
⑵
.
●
Front left and right shock absorption
Remove the bolts
⑵
on the lower link, and hold the shock absorber in the middle with one hand. Insert a slotted
screwdriver into the slot of the upper and lower plates to slightly enlarge the slot clearance, and disassemble the left shock
absorber
⑺
and the right shock absorber
⑻
. under. Remove the upper plate assembly.
●
Reflecting film
The reflector
⑼
is for replacement after sale (no shock reduction). The heat-reflecting sheet can be moved back and forth
by a hot air blower to reduce the viscosity of the double-sided adhesive after being heated, and the residual glue should be
cleaned after removing the reflector.
●
Faucet lock
Remove the bolt
⑽，
and the spring washer
⑾
and the faucet lock
⑿
.
CAUTION:
●
Remove the head assembly, switch, cable, balance block, etc. according to the previous operation.
●
Remove the direction of the assembly can not be rotated,rpevent scratching of paint
。
●
Use a flat-blade screwdriver to enlarge the gap between the upper and lower joint plates without applying excessive force
to avoid damage
●
When disassembling the shock absorber, move to the axis direction, do not rotate or swing to prevent surface scratches.
●
Old faucet lock can be replaced as new models.