Zontes ZT250-R, Руководство по обслуживанию

Страница: 62 / 76

8-FUEL TANK COMPONENT
61
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1250105-137093 GB5789M6×16 (environmental color) 8
2 1050953-020000 T02 built-in fuel pump 1
3 4034100-006000 Fuel tank inner tank 1
4 1244100-002000 Side cover round rubber 4
5 1240300-021000 Plastic piece 0.17
6 1224100-033000 Fuel tank cap 1
7 1224200-066000 ZT310PKE External antenna mount 1
8 1164100-006000 T02 oil level sensor 1
FIG.5 FUEL TANK INNER
COVER
Fuel tank inner tank
PROCEDURE:
●
Fuel pump
Place the tank inside the tank and place it firmly and remove the bolt
⑴
with the sleeve.
When the fuel pump
⑵
is removed, do not bend or bend the float rod
②
to prevent the oil output from being
inaccurate.
●
Side cover round rubber
Squeeze the side cover round the side of the glue
⑷
with your hand and squeeze it out of the tank.
●
Plastic piece
Use your hand to tear off the tape
⑸
counterclockwise. at the end of the tape.
●
Fuel tank cap
Tighten it by hand
③
Remove the fuel tank cap by turning it counterclockwise
⑹
, be careful not to pull the nylon
rope
④
.
●
Fuel tank cap
After removing the antenna fixing block
⑺
from the inner container assembly, clean up the remaining glue.
CAUTION:
●
When disassembling the tank assembly, it is recommended that the fuel be pumped out by the fuel pump or
consumed at first.
●
Fireworks should be strictly prohibited in the vicinity of the motorcycle repair place, answering or dialing, etc.
to prevent accidents.
●
Reverse the tank assembly. When removing the fuel pump, be sure to check whether the fuel tank cover has
been tightened to prevent residual fuel from escaping from the tank port; there may be a small amount of fuel in
the vent pipe
①
when the tank cover is removed.
●
When reassembling the fuel pump, be sure to clean the joint surfaces of the clean fuel pump seal pad and the
tank liner. When locking the bolt, ensure that the seal gasket is evenly deformed by staggering the position.
●
It is forbidden to forcefully pull the cable when removing the timer lock.
●
When assembling the fuel tank cap, pay attention to rotating
③
to the position shown in the figure. In other
positions, it may interfere with the process clip of the fuel tank cover.
●
T02 oil level sensor dose not contain fuel pump body
。
Make sure you have the ability to change it.