Zontes ZT250-R, Руководство по обслуживанию

Страница: 58 / 76

8-FUEL TANK COMPONENT
57
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1250205-043093 GB70.1M8×55 (environmental color) 2
2 1251900-028093 Fuel tank flat gasket (environmental color) 2
3 1244100-020000 Fuel tank press rubber 2
4 1244100-053000 Fuel tank gasket rubber 2
5 1274100-080000 Seat fixed block 1
6 1050954-006000 Fuel injection high pressure subcomponent 1
A
B
FIG.1 FUEL TANK INNER
COVER
Fuel tank inner tank component
PROCEDURE:
●
Fuel tank inner tank component
Short press the unlock button " ", after the power-on self-check is completed, short press " " to open the
outer cover of the fuel tank. Be careful not to close the outer cover of the fuel tank.
Remove the bolts
⑴
with the inner hex tool; Remove flat gasket
⑵
and press rubber
⑶
.
Lift the rear of the tank, remove the gasker rubber
⑷
and fix the seat block
⑸
.
Locate and unplug the cable connector of the electronic fuel tank lock near the front of the right side cover
(Figure A)
Locate and unplug the electronic PKE external antenna cable connector near the front of the left side cover
(picture B).
Pull the main line limit card
①
into the outside and pull out the plug.
Find the limit card ring
②
on the top of the high pressure tubing unit
⑹
, and press the pressure to the outside.
Continue to raise the tank's bladder component, clamp the pipe clamp on the air pipe by the arrow direction, and
remove the vent pipe.
Move the tank inside the tank slightly to the left and right and then pull back to the top.
CAUTION:
●
Remove the seat cushion, side cover, fuel tank cover, etc. in advance.
●
When the high pressure fuel pipe is removed, it must be operated after the engine and muffler are completely
cooled to prevent accidental ignition of the fuel.
●
Fireworks should be strictly prohibited in the vicinity of the motorcycle repair place, answering or dialing, etc.
to prevent accidents.
●
A small amount of fuel leaks when the high pressure pipe subassembly is pulled out. Prevent the fuel from
dripping outside the engine or muffler.
●
When disassembling the tank assembly, it is recommended that the fuel be pumped out by the fuel pump or
consumed at first.