Thermo Scientific thermoscientific Vanquish Pumps C, Руководство по эксплуатации

Страница: 75 / 296

5 • Installation
Pumps C, Pumps F ( VC-Pxx, VF-Pxx)
Operating Manual Page 75
No. Description
6 Peristaltic tubing
7 Seal wash tubing to pump head
1. Press down the lever on the seal wash pump and hold it in that
position with one hand.
2. With your other hand, insert the tubing between the lever and the
rotor and wind it around the rotor.
3. Release the lever.
4. Check that the peristaltic tubing is inserted properly in the tubing
holders. If it is not, push the tubing into the holders. Make sure that
the tubing is not pinched or squeezed in the holders.
5. Check that the right tubing connector rests on the tubing holder. If it
does not, push the tubing connector onto the holder.
Connecting the Seal Wash Line between Autosampler and Pump
1. In the autosampler, locate the seal wash line (clear silicone tubing)
to the pump:
¨
Single split sampler: The seal wash inlet port is located on the
top enclosure frame (right tubing connector). The seal wash line
to the pump is interconnected to the seal wash inlet port.
¨
Dual split sampler: The seal wash inlet port is located on the
right enclosure frame (top tubing connector). The seal wash line
to the pump interconnects seal wash inlet and outlet port.
2. Disconnect the seal wash line from the seal wash inlet port.
3. Route the seal wash line from the seal wash outlet in the
autosampler through the tubing guides to the peristaltic tubing in
the pump.
¨
Single split sampler: The seal wash outlet is located on the
bottom end of the metering device.
¨
Dual split sampler: The seal wash outlet is located on the right
enclosure frame (bottom tubing connector).