Thermo Scientific thermoscientific Vanquish Pumps C, Руководство по эксплуатации

Страница: 195 / 296

7 • Maintenance and Service
Pumps C, Pumps F ( VC-Pxx, VF-Pxx)
Operating Manual Page 195
NOTICE
• Verify that the screws are tightened. Pull the slide-in module by the
leak tray towards the front and check whether the screws move. If
they do not move, the slide-in module is installed properly.
• If the screws move, tighten the screws further. With a torque
wrench, the recommended torque is 1.2 Nm.
8. Set up and restart the device.
7.16.4 Setting Up the Slide-In Module
After you have reinstalled the slide-in module in the enclosure, set up
and restart the device.
Follow these steps
1. Set up the slide-in module:
a) Connect the slide-in module and set up flow connections (see
Installation (
}
page 45) ).
b) Prepare the slide-in module for first-time operation (see
Preparing the Device for Operation ( } page 95) ).
2. Prepare all other modules of the Vanquish system for operation and
restart them. Refer to the Operating Manuals for the modules.
3. Before starting an analysis, let the chromatography system
equilibrate and be sure that it is ready for operation.
4. From the Chromeleon software, perform performance qualification
for the pump:
¨
Run the pump-specific Performance Qualification tests (PQ
tests) (= Flow Precision Test and Gradient Accuracy Test). For
details, refer to the
Operational and Performance Qualifications
manual .
¨
When the tests are completed, execute the QualificationDone
command.